Servo Cables and Y Adapter

30cm/12″ servo extension cable – set of 10 cables

Basic servo extension cable. Male connector on one end and female connector on the other. 3-wire 26AWG cable. Works with servos and fascia controllers. Sold in a set of 10.

90cm/36″ servo extension cable – set of 10 cables

Basic servo extension cable. Male connector on one end and female connector on the other. 3-wire 26AWG cable. Works with servos and fascia controllers. Sold in a set of 10. Note – will ship either 90cm or 100cm cables based on current stock.

“Y” servo cable 30cm/12″ – set of 10 cables

“Y” servo extension cable. Female connector on one end and two male connectors on the other. 3-wire 26AWG cable. Works with servos and fascia controllers. Sold in a set of 10.

“Half” Cable 15cm/6″ – set of 10 cables

“Half” servo extension cable. Male connector on one end and open wires on the other end. 3-wire 26AWG cable. Solder the open end wires to stall motors, pushbuttons, LEDs, etc then add standard extension cables as needed. Sold in a set of 10.

“Y” Adapter Board

Provides four “Y” connections for one QuadLN_S I/O Port. This is an effective alternative to using “Y” cables when you want to split into two cable runs right at the QuadLN_S. Comes with standoff and mounting screw.