Remote Align Board

The QuadLN_S product family is back in production and Rio says we have to celebrate! Enter code RioSays20 at checkout for 20% off your entire purchase.

$14.95

Use this board to align your QuadLN_S servos, set Detector sensitivity and adjust Signal LED brightness.  Just one of these boards is needed for all of your QuadLN_S’s.  Comes with a cable which allows you to stand next to your turnout while aligning the servo – no more hanging upside down below the layout!  

A Remote Align board is required to perform firmware updates.

Note – the cable connector is a tight fit, so please take your time and support the mating socket when inserting or removing the cable.